At Hitech we perform chassis dyno tuning on a 1,800 wheel hp capacity DynoJet 248 chassis dynamometer. Because of its simplicity, reliability and repeatability, it is the standard in the industry. Front or rear wheel drive, gas or diesel, you will always get honest, accurate power numbers and there is never an extra charge for A/F data or complete printouts.

Our chassis dyno setup is different than most other chassis dynos for the following reasons:

1. The dyno cell has viewing areas on 2 sides with remote monitors so you can watch your car being run in safety and comfort.
   
   
2. Being a true dyno "cell" and not just a dyno parked in the middle of the shop floor, it is run with a 25,000 cfm ventilation system to maintain a clean, stable testing environment to guarantee a consistent, repeatable test result. It's very common here to make back to back runs on a 500HP car within 1HP of each other.... as we say, you can't find 2HP if you can't repeat within 5.